Solar recessed outdoor spotlights

This selection is also available in our French store: Spots d exterieur encastrables solaires

No products in this selection.

  • Tracked delivery to your country Tracked delivery
  • Secure payment at checkout Multiple payment methods
  • 14 days to change your mind 14-day returns
  • Secure payment Secure payment
Designix guides you

Not sure of your style? Find it in 30 seconds

A few questions, and we will show you the pieces made for you.

Frequently asked questions

How do I choose the right light output?
Allow about 100 to 300 lumens per m²: about 150 lm/m² for a living room, about 350 for a kitchen. Each product page lists the lumens.
At what height should the light be installed?
Above a table: 70-85 cm from the tabletop; in a walkway: at least 2.10 m of clearance below the bulb.
What type of bulb?
Usually E27 or E14, sometimes GU10. Specified on each product page.
Compatible with LEDs and dimmers?
Yes, in most cases; for use with a dimmer, look for the “dimmable” mention.
Solar recessed outdoor spotlights
Designix · Design lighting

Light changes everything

From statement chandeliers to discreet wall lights, we help you choose the right brightness, height and style for every room.

  • Tracked delivery
  • Pay in instalments, where available
  • 14 days to change your mind
  • Advice & showroom in Lyon, France
Read our guide

Count three spots aligned along a path or a deck board: set low, they draw a path of light without glare and blend into the surface. Because they run on solar energy, they install without cable or trench and turn on by themselves at dusk.

What does a solar recessed outdoor spotlight change on a terrace or in a garden?

Recessed into a terrace, a path or a slab, these spots need a cut-out in the surface and a fixing suited to the material. Their low light reaches a short distance and guides without glare.

What a solar recessed spot brings outside

No cable to run, no trench to dig, no socket to pull from the house. The fitting sits in the surface and the panel stays turned towards the sky. The grazing light underlines a wood board, a paver or a low wall, and the surface stays flat: you walk on it without thinking. These outdoor spots that run on solar energy therefore suit areas where bringing power would cost more than the lighting itself.

Marking, lighting or underlining: three different uses

Marking means flagging a path or a step. Lighting means making an area usable, the edge of a terrace for example. Underlining means highlighting a facade, a trunk or a low wall. The trade-off is real: output depends on the sun received. Under dense foliage, under furniture or in a closed yard, the battery recharges poorly and the light weakens. The rest of the catalogue can be browsed in all Designix light fittings.

How does a solar recessed outdoor spotlight work?

The solar panel charges a battery during the day; at dusk, a photocell switches the LED on, then it goes off at dawn or after a set duration. The amount of sun captured, and therefore the orientation of the panel, decides the runtime and the consistency of the light.

What the fitting contains

Four elements work together: a photovoltaic panel, a rechargeable battery, a photocell and an integrated LED. When the LED is integrated, it cannot be replaced; the whole fitting lives its life. For a steadier light and a cleaner result, look at solar spots in LED version.

Why panel orientation decides everything

A panel in the shade charges little, even if the spot is well placed and well fixed. Clear it of foliage, planters and deep awnings, then aim it at the brightest hours of the day. If the surface takes splashes or stays damp, compare with recessed spots powered by LED connected to the mains.

Where to recess a solar spot: terrace, path, facade or pool edge?

A solar spot is recessed wherever the panel stays exposed: deck boards, slabs, pavers, low walls, underside of an awning or pool edge. The surface dictates the cut-out and the fixing, the solar exposure dictates the result: a panel in the shade recharges poorly.

On a wood board, a clean housing prevents water from pooling around the fitting. On slab or paver, the cut-out is made at the time of laying, much harder afterwards. Along a path, alignment matters more than power. These principles apply to the whole range of recessed outdoor spots.

Which solar recessed spot for which area to light
Area to light What matters most Type of spot to favour Watch-out
Wooden terrace or slab Cut-out in the surface and panel exposure Adjustable solar recessed spot Panel clear, not under furniture or a planter
Path and border Alignment and low light without glare Fixed solar recessed spot Regular spacing along the path
Facade and low wall Discretion and rain resistance Recessed spot with a suitable IP rating Light downwards rather than towards windows
Underside of an awning Exposed panel and light aimed at the ground Adjustable recessed spot Avoid the area where water runs off
Pond or pool edge Robustness and splash protection Recessed spot in a resistant material Do not aim at the water surface

What to look for when choosing solar recessed outdoor spots?

Start with the material and the IP rating, which decide how it holds up outside; then the orientation, fixed or adjustable depending on whether the light should mark a path or aim at a precise point; finally the colour and the shade of white, to blend into the surface or contrast.

Material, IP rating and colour

This collection contains only one solar recessed spot, with no specifications listed for now. A outdoor spot in a light colour disappears on a pale slab. Conversely, a model in a dark colour draws a clean line on pale paving.

Fixed or adjustable: what it changes in use

A fixed spot spreads wide and low, perfect for marking a path. An adjustable head lets you aim at a trunk, a door number or a low wall, and correct a layout mistake without taking anything apart. See the recessed models with an adjustable head. For a softer result on a pale facade, the white LED outdoor fitting blends into the render.

What each criterion changes on a recessed outdoor spot
Criterion What it changes What to check
Material Resistance to UV, moisture and impacts Surface treatment and quality of the seals
IP rating Resistance to rain and splashes A high rating holds up better outside
Adjustable or fixed Marking a wide area or aiming at a point Range of adjustment of the head
Colour Blending into the surface or contrasting White, black or a shade matching the surface
Shade of white Warm mood or a more neutral result Warm white for mood, more neutral for legibility
Integrated LED or socket Replacing the bulb or not An E27 socket lets you change the bulb

How to wire spots in series or in parallel?

In series, the spots share the voltage and all go out if one fails; in parallel, each receives the same voltage and works independently, which remains the solution for a set of spots. Solar models, self-contained, escape this choice since they have no cable.

Series or parallel: what changes day to day

In series, a single faulty point cuts the whole line and the search becomes tedious. In parallel, each spot lives its own life: you replace one without touching the others. That is why an outdoor set is almost always wired in parallel, whatever the number of points installed.

And for a self-contained solar spot?

The question does not arise: the solar spot carries its own power supply and remains a self-contained fitting, with no connection or terminal blocks to tighten. What replaces wiring is the placement of the panel. If the mains is already run and you want to dim the intensity, look instead at dimmable recessed spots.

How to lay out spots on a ceiling and under an outdoor soffit?

Align the spots on the grid of the room or the awning, spacing them regularly from the wall and from each other rather than scattering them. Near a wall, keep them away from it to avoid patches; outside, follow the line of the overhang or the lit border.

Under an awning or a roof overhang

Align the points on the line of the overhang and keep them away from the wall: too close, the light climbs up the facade instead of lighting the ground. Check that the panel catches the sun and not the shadow cast by the roof. Adjustable outdoor spots correct an imperfect layout without drilling again.

Under an indoor ceiling: the same principles

In a hallway or a kitchen, the grid stays the same: regularity, distance from the wall, an axis followed from one end to the other. For indoors, compare the adjustable models for indoors. If the room suits it, recessed spots for the living room follow the same alignment logic.

How many spots in a kitchen, on a terrace or in a hallway?

There is no fixed number: start from the areas to light, worktop, circulation, terrace edge, then add points until they are covered without leaving a dark gap. Then check what the circuit or the solar charge can reasonably supply.

Defining the areas before counting avoids buying at random: a worktop needs light placed in front of you, not behind your back. A path is satisfied with a few regularly spaced points. Checking the power supply comes next, especially when the solar charge stays modest. For indoors, compare the recessed spots for the kitchen. In a narrow passage, the hallway special settles the question of grazing light.

Is an E27 bulb suitable for an outdoor fitting?

The E27 socket is the most widespread screw format: it lets you replace the bulb of an outdoor fitting designed for that socket. What matters outside is that the fitting is protected from moisture and that the bulb withstands the outdoors; a solar spot with an integrated LED uses no bulb.

The E27 socket changes one concrete thing: the ability to change the shade or replace a tired bulb without taking the fitting down. Conversely, an integrated LED means replacing everything the day it weakens. The two approaches are compared in the LED version for the kitchen and in the adjustable LED outdoor models, depending on whether you light indoors or outdoors.

Outdoor wall light for a terrace or recessed spot: which to choose?

The wall light is fixed proud on a wall and lights downwards or at working height; the recessed spot sits in the surface and disappears. To mark a terrace without drilling a wall, the solar recessed spot is more discreet; the wall light suits when the wall is already equipped.

A wall light needs an electrical point on the facade and lights wide, often more strongly than a recessed spot. A spot recessed in the ground or a slab is walked on, blends into the surface and guides the step. The choice therefore hinges on the available surface as much as on the desired effect. For looks, see the models designed for outdoors.

One last point before ordering: measure the cut-out needed in your surface and the possible orientation of the panel. That is what decides the result, more than the fitting's specification sheet. Choose your solar recessed spot then check compatibility with your terrace or path.

At Designix, payment is secure, delivery is tracked and returns are possible. Customer service answers installation and compatibility questions before purchase as well as after. The full catalogue can be browsed in the complete lighting collection.

Frequently asked questions about solar recessed outdoor spots

Does a solar recessed spot work in winter or in cloudy weather?

It works, but for less time and often less strongly: low sunshine recharges the battery less. Aim the panel at the brightest hours, keep it clear of foliage and accept reduced runtime on grey days.

Can a solar spot be recessed into a wooden terrace?

Yes, provided the board or slab is cut out cleanly and the panel stays clear. Recessing requires fixing to the surface, panel exposure decides the result. On wood, a clean housing prevents water from pooling around the fitting.

Which E27 bulb should I choose for an outdoor fitting?

Choose a bulb intended for outdoor use, fitted in a light whose E27 socket is protected from moisture and splashes. The E27 socket imposes neither shade nor power: the fitting is what must suit rain, condensation and wall exposure.

How do I choose an outdoor wall light for a terrace?

A wall light is fixed proud on an available wall, at working height, and lights downwards to avoid glare. Check its rain resistance and its direct exposure to the weather before fitting it near a door or under an overhang.

How many spots in a kitchen?

There is no fixed number: start from the areas to light, worktop, sink, circulation, then add points until they are covered without leaving a dark gap. Take into account the ceiling height and what the circuit can supply.

Our advice for choosing
Recessed solar outdoor spotlights illuminate a patio, a driveway or a facade with no wiring or trenching: the panel recharges the battery and the spotlight switches on at dusk. These models are chosen on the basis of material, protection rating, orientation and type of light.