220V LED Strips

A 240V LED strip light fixture connects directly to the home's mains supply through its terminal block, with no transformer or driver to house in the ceiling. The strip, enclosed in a ceiling light or pendant, draws a continuous line of light rather than an isolated point. All models in this selection are IP20 rated: dry, sheltered rooms only.

What is a 240V LED strip light fixture?

A 240V LED strip light fixture connects directly to the home's mains supply, with no visible transformer or driver. The strip, housed in a ceiling light or pendant, diffuses a continuous light. All models in this selection are IP20 rated, so they are reserved for dry, sheltered rooms.

A flexible strip is usually fitted by yourself under a cabinet or along a skirting board. Here, the strip is built into the body of the fixture: the installation changes, and so does the result. If you are looking for a strip to fit yourself, LED strip lights are chosen on other criteria.

240V LED strip without transformer: how it connects

The fixture's terminal block takes the mains wires like any other light point. Switch off at the breaker, identify live and neutral, tighten the screws. No box to hide in the ceiling, no trunking needed for a driver, which makes installation easier on a finished ceiling. The Rubano ceiling light with its zigzag strip follows this principle.

240V LED strip on a switch: what to plan for

A standard wall switch is enough, since it cuts the power to a fixture that runs on mains. Allow access to the terminal block when fixing it and check that the switch actually controls the relevant circuit. For comparison, 24V low voltage LED strips require a dedicated power supply unit.

Which wattage for a 240V LED strip?

The wattage is stated on the product page: this selection ranges from 15 W to 45 W. The Moln pendants draw 15 W, the Vorada ceiling lights 25 or 29 W, the Rubana pendant 31 W and the Rubano ceiling light goes up to 45 W. The higher the figure, the more presence the fixture has in the room.

15 W, 25 W, 29 W or 45 W: reading the product page

You will find wattage, bulb fitting and material in the same place: the 45 W of the Rubano corresponds to a white metal ceiling light, the 31 W of the Rubana to a black aluminium pendant. Wattage is a measure of consumption and light presence, not a promise of a particular effect. For a comparison point across the whole home, browse our full range of light fixtures and their product pages.

Choosing the wattage according to the room

A low wattage suits accent lighting and small spaces, a high wattage suits a large area that needs broad coverage. The Moln are 15 W for accent lighting, the Rubano 45 W for a living space, the Vorada from 25 to 29 W. For a damp room, a COB IP65 strip in neutral white works well. 12V and 24V strips run through a transformer, while 240V connects directly.

Cuttable LED strip: how does it work?

A cuttable LED strip may only be cut at the marks indicated by the manufacturer, never elsewhere, otherwise the section becomes unusable. Cutting is used to adjust the length to the cabinet or ceiling. Check the model's product page to see whether cutting and dimming are stated.

240V cuttable LED strip: locating the cut points

The marks are printed at regular intervals along the strip. Cut at these marks, with straight scissors or pliers, never in the middle of a section: the part beyond an off-mark cut is no longer supplied correctly. Nothing indicates that the models in this selection are cuttable: this point must be checked page by page.

240V dimmable LED strip: checking the product page

A dimmable strip or fixture must be stated as such. Without that mention, it cannot be controlled with a dimmer and accepts neither a remote control nor a dimming module. For uses where dimming matters, RGB LED strips and controllable ranges meet that need.

LED ceiling light, LED chandelier or LED wall light: how to choose?

The ceiling light is fixed to the ceiling and lights broadly at low height. The pendant hangs above a table or in a tall space, like the Rubana with its adjustable height. The chandelier multiplies the light points, a role played here by the Moln three light pendant. The wall light completes the scheme as accent lighting.

These families combine more than they compete. The choice depends mainly on the available height and the spot you want to highlight. The rest of the catalogue can be seen in our range of light fixtures for the home.

Modern LED ceiling light: what sets it apart

A contemporary ceiling light plays on the shape of the strip and the visible material: zigzag strip in white metal on the Rubano, wrapped white strip on the Vorada ceiling light with wrapped strip. It stays flush against the ceiling and does not drop into the field of view, which makes it practical in a hallway or a room of average height.

Wall light and LED chandelier: when to prefer them

The wall light illuminates a precise area, a corridor, a reading corner, without touching the ceiling. The chandelier distributes light across several points and becomes a decorative feature. Both are chosen in IP20 for a dry room, like the rest of this selection.

Which LED ceiling lighting for a living room?

For a living room, a wide ceiling light like the Rubano, 510 mm long, covers the room with even light, while a pendant provides a focal point above the sofa or coffee table. A wall light fills in the shaded areas without adding another source to the ceiling.

LED living room ceiling light: which format to choose

The Rubano measures 510 by 410 mm with a height of 120 mm, the Vorada 600 mm long by 170 mm. The lower the ceiling, the more you gain from a flat model. For a large living room, aim for a fixture size in keeping with the room rather than a single point. The collection has 17 products.

LED living room wall light: completing without overloading

Rather than multiplying sources on the ceiling, a wall light placed on either side of a sofa or a bookcase illuminates where the shadow is a problem. A strip ceiling light, which lights broadly in the centre, pairs well with two discreet wall points. See the lighting catalogue for available formats.

Which model for the kitchen, dining room, bedroom or hallway?

The models in the selection are listed for the kitchen, dining room, hallway, living room and bedroom; some pendants also suit a staircase or an office. The choice comes down to format, available height and the type of light wanted, with warm white light on some of the references.

Kitchen and dining room: light for the worktop

Above a worktop, a flat ceiling light illuminates without creating troublesome shadows, and its 120 mm height keeps it out of sight. Above a table, a centred, adjustable pendant prevents glare. Both can coexist in the same open-plan room.

Bedroom and hallway: favour compact formats

A ceiling light 170 mm high fits into a bedroom or corridor without taking up space. The warm white light noted on the Vorada models suits a room for rest, with colour temperatures around 2700 to 3500 K. For other moods, look at 2700K LED strips and 3000K LED strips.

How to install and maintain a 240V LED strip light fixture?

Installation is limited to connecting to the mains, then fixing it to the ceiling or support. For a clean job, cut the power at the breaker, check the height before drilling and keep access to the terminal block. Maintenance is done with a soft cloth, without abrasive products on the white strip.

Professional 240V LED strip: what sets a clean installation apart

A neat installation is recognisable by three things: an accessible terminal block, fixing aligned with the walls, and wires that do not hang down into the space. Plan the cable route before drilling. For damp rooms, you need a different product family, such as waterproof LED strips for damp rooms.

Maintaining a wrapped white strip

A wrapped strip is dusted with a soft cloth or a dry microfibre. Avoid abrasive products and sponges, which scratch the casing and dull the diffusion. Regular dusting is enough to keep the light even on the white models, which are the majority in the selection.

How to compare the strip ceiling lights and pendants in this selection?

First compare the type, ceiling light or pendant, then the material, colour and wattage. The Rubano is a 45 W white metal ceiling light, the Rubana a 31 W black aluminium pendant with a Ø 60 cm shade. The Vorada and Moln rely on the wrapped white strip, at 15, 25 or 29 W.

Type, format, wattage: the order to read a product page

First line: the type and format, which determine the installation. Second line: the wattage and bulb fitting, which determine the light presence and any replacement. Third line: the colour, material and warranty, stated as three or five years depending on the model. The Rubana black spiral pendant reads this way.

Integrated LED or E27 fitting: what changes day to day

Integrated LED cannot be replaced: nothing to plan, nothing to match. The E27 fitting accepts a standard bulb, as on the small Moln with E27 fitting, which leaves the choice of colour temperature and allows a bulb to be replaced without changing the fixture. Neither is superior: it is a question of use and the maintenance you want.

To choose between two formats, take into account the ceiling height and the surface area: a ceiling light 120 mm high like the Rubano frees up the space, an adjustable pendant like the Rubana adjusts from 45.7 to 325.7 cm. These two references are enough to decide in most rooms. See its 60 cm version and the Moln three light pendant for large spaces, then our selection of LED strips for other types of installation.

Frequently asked questions

Secure payment, tracked delivery, returns and Designix customer service accompany every order. For a customisable mood, RGBW LED strips and see the whole Designix lighting catalogue complete the selection.