Resin table lamps

Plan on one resin table lamp per side table: a large sculpted piece on the living room sideboard, a shorter format on the bedside table. Polyresin is worked into solid, opaque silhouettes, so it gives a side halo of light rather than general illumination, and serves as a decorative object as much as a light source.

Which resin table lamp should you choose for the living room or bedroom?

The choice comes down first to the room and the surface: a large sculpted lamp like Ilora or Golfa marks out a corner of the living room, while a compact format like Nomia fits on a bedside table. Then come colour and height, to be matched with the piece of furniture it sits on.

Resin table lamp: where do you start?

First measure the furniture that will hold it: a narrow console copes badly with a 36 cm diameter base. Then look at the height available under the shelf or the picture, and only then at the shade. For a living room, browse the table lamps for the living room and note the free space in the corner near the sofa. In the bedroom, the bedside models for the bedroom keep their width down to leave room for a book and an alarm clock.

Two rules of thumb are often enough: the lamp should not exceed a third of the width of the furniture, and its light point usually sits at shoulder height when you are seated. The large sculpted lamp with three elephants suits a wide sideboard, while Nomia, a compact black format, is intended for a side table or a desk.

Resin or ceramic: what difference does it make day to day?

Polyresin allows highly elaborate silhouettes, with hollows and fine ridges, and stays solid and opaque. Ceramic gives a smooth, often glazed finish, more classic and visually heavier. Ceramic lamps fit into a restrained interior, while sculpted resin asserts the presence of the object, like an animal statuette. For care, both are cleaned with a soft cloth, but ceramic is more vulnerable to knocks on the corners.

What light does a sculpted resin table lamp give?

Polyresin is opaque: the light comes out through the top or through the openings in the model, illuminating the room without passing through the material. The result is accent lighting, placed near an armchair or a piece of furniture, which creates a halo on the wall rather than general illumination.

What difference does opaque resin make to light diffusion?

Nothing filters through the wall: depending on the shape, the light rises towards the ceiling, washes the wall behind or comes out through a slot. The result is softer than a bare source, with no glare when you are sitting next to it. Count this lamp as a third light point in a room, after the ceiling light and another low source, not as the main lighting.

How should ceiling spotlights be arranged with a table lamp?

Distribute the spotlights by zone rather than in a regular grid, and avoid placing one directly in line with a sofa or a bed: the eye receives the source full in the face. Once the upper part of the room is lit, the table lamp takes over with low, localised light, near the furniture where it is installed. If you are looking for an even lower source, look at the adjustable models, which can be aimed at the wall or at the page.

For versions with an integrated source, the design LED versions save you having to choose a bulb and simplify connection.

How do you match a gold, black, beige or brown resin lamp?

Gold warms and catches the light, black stays discreet and graphic, beige blends into pale walls and brown converses with wood. One colour is enough in a room that is already busy; otherwise the lamp can echo the tones of the furniture.

Gold and black: which combinations?

Gold works on a pale wall, where it reflects daylight, and on a dark background, where it stands out by contrast. Black goes with furniture legs, frames and handles. The gold and black duo remains the simplest combination when the room already mixes both shades. For a fully contemporary living room, the black selection for a living room holds the line without drawing the eye.

Which colour for a Nordic or modern decor?

A Nordic interior calls for pale shades and understated shapes: the beige of Equora slips in without a break, next to pale wood furniture. The Nordic spirit also accepts matte white and straight lines. A modern room, with more contrast, takes black and graphic silhouettes, which can be found in the modern living room lamps. Brown, finally, pairs with walnut or smoked oak furniture.

Large sculpted lamp or compact lamp: which format should you choose?

A sculpted lamp almost a metre tall goes on a low piece of furniture or a wide sideboard, while a model of 40 to 55 cm finds its place on a console or a bedside table. Height and the footprint of the base matter more than colour alone.

Table lamp or floor lamp: what difference?

A table lamp occupies a piece of furniture, so a surface that is already useful: it takes up no floor space and moves from one room to another. A floor lamp, on the other hand, stands in a corner and is often used for reading. In a small living room, the first avoids cluttering the walkway; in a large empty room, the second fills the height. The two coexist easily as long as they are not stuck right next to each other.

Design globe table lamp: what is it used for?

A round silhouette, placed on a piece of furniture, lights in all directions and suits a soft atmosphere rather than reading. It goes on a hallway console to welcome, or on a dining room sideboard at the end of a meal. For a workspace, choose a low, stable model: lamps designed for the desk bring the source down to the level of the page.

How do you connect several lamps to a single electrical supply?

Several lamps can be connected to the same supply: they are wired in parallel, each tapping into the live and neutral, and the power is switched off before any work. A junction box or a row of sockets connected to the line is enough for three lamps.

Connecting three lamps to a single switch

The three feeds leave the same box: live with live, neutral with neutral, and earth with earth if the light fittings have one. The switch goes at the head of the circuit and controls the whole set with a single action. Tighten each connection, close the box, then switch the power back on to test. If the lamps have sockets, keep the wattages consistent with each other.

Connecting several lamps in parallel: the precautions

In parallel, each lamp receives the same voltage and switches on independently: this is the setup to use. In series, the sources would share the voltage and give less light, a setup to avoid here. Switch off the circuit breaker before any connection, do not mix cable sizes and have a new line installed by an electrician if the existing circuit is already loaded. All our light fittings connect to a standard socket or supply.

Where should you place a sculpted lamp in the living room or bedroom?

In the living room, the sculpted lamp goes on a sideboard, a console or a side table, in a corner or next to a sofa, away from walkways. In the bedroom, it is set back on the bedside table, on the wall side, so that the light stays behind your shoulder when you read.

On a sideboard, a console or a bedside table?

The central sideboard remains the most natural spot for a large piece: it fills the space above the furniture. A hallway console calls for a narrower model, like Equora and its 32 cm length. In the bedroom, the bedside table imposes a limited height: Noxel and its 37.5 cm fit under a low headboard. A desk, finally, takes a compact format placed at the end of the worktop.

How do you combine it with the other lamps in the room?

One sculpted lamp per zone is enough: two strong pieces side by side cancel each other out. In a living room, combine it with a discreet ceiling light or a wall light, and keep the low source for the evening. In the bedroom, the bedside lamp plays the main role and often replaces any other lighting at the end of the day. Wooden lamps offer a warm alternative if you prefer a more matte material.

How do you care for and stabilise a polyresin lamp?

Polyresin is cleaned with a soft, slightly damp cloth, without abrasive products. Unplug it first, avoid wetting the base and check that the lamp sits flat, with the cable unwound, so that it does not tip over when you move it.

Cleaning a sculpted resin lamp

Dust collects in the hollows of the sculpture: a microfibre cloth is enough for the surfaces, a soft brush for the recesses. A barely damp cloth removes marks, then dry straight away. Avoid alcohol, acetone and abrasive sponges, which dull the finish. Never immerse the piece, even if the surface seems solid.

Cable, base and moving: the checks

Resin is dense: a 98 cm piece is lifted with both hands, under the base, never by the top. Check that the cable is not trapped under the furniture and that there is enough slack to move the lamp without pulling on the plug. If the floor is slightly uneven, a felt pad under the base corrects the seating. To compare materials, crystal pieces need a dry cloth, without water.

Italian, Nordic or modern design table lamp: which style should you choose?

The term Italian design refers to a style: sculpted shapes, gilding, assertive silhouettes, rather than a country of manufacture. It can be found in the gold and elaborate models in the collection, alongside a more Nordic or modern spirit depending on the colour and the line of the base.

What is meant by an Italian design table lamp

Generous curves, gold finishes and figurative subjects are what bring these models close to the Italian family. Golfa, with its sculpted golfer and gold finish over 80 cm, gives the idea. The Noxel gold owl lamp plays the same register in a smaller format, on a bedside table. None of these pieces claims Italian manufacture.

Resin, wood, metal: changing material according to style

Material changes the style more surely than colour. Black metal leans contemporary and towards the desk, wood towards the warm, sculpted resin towards the decorative object. Here is an overview of the materials, to place resin among the others.

In this collection, the five polyresin lamps measure from 37.5 cm to 98 cm high, in gold, brown, beige and black. To place these models, see the Designix lighting range, and the bedside ceramics offer another possible entry point.

One last piece of advice before you decide: measure the furniture and note the clear height, then choose the colour according to the wall that will be behind it. It is this pairing of height and shade that decides the result, far more than shape alone.

Frequently asked questions about resin table lamps