Outdoor LED strip lights

Count on a continuous line of light rather than an isolated point: an outdoor LED strip light mounts on a wall or ceiling and casts an even glow along its entire length. It highlights a facade, a canopy or a walkway, where a wall light or ceiling light only illuminates one precise spot.

What light does an outdoor LED strip light give?

It produces a linear, even light with no harsh shadow, projected downwards or upwards depending on the mounting. The beam follows the length of the fixture: a wall, a facade or a walkway is lit as one piece, instead of an isolated circle of light. That is what sets it apart from a wall light or a ceiling light.

Under a canopy or an overhang: light that follows the length of the wall

Mounted on the ceiling or under the structure, the strip light illuminates the walkway along its entire length. In the evening, the facade stays readable and the ground gets no patch of light. This continuity avoids stacking several small fixtures under one canopy. To compare other effects, browse our lighting catalogue.

Path, stairs, entrance: lighting without glare

Above a path or a staircase, aim the beam towards the ground or the wall, never towards the eyes. Mounted higher, the strip light gives a wide, soft light; mounted low, it highlights the steps. A spotlight concentrates light on one point and leaves the rest in shadow, which all our LED strip lights avoid along a continuous line.

How do you choose the length of an outdoor LED strip light?

First measure the area to be lit, then the distance between the fixing points and the cable entry. The longer the wall, the more a continuous line avoids multiplying fixtures. Then check the cutting options offered by the manufacturer before confirming your choice.

60, 90, 120 or 150 cm strip lights: how do you place the right size?

A short size suits a gable, a narrow walkway or a staircase. A long size covers a canopy, a garage or a terrace wall as one piece. On a large wall, two well-spaced lines beat an accumulation of small, poorly aligned fixtures, for example on a ten-metre facade. The general collection of strip lights gathers the common sizes.

Cuttable LED tape: how does it work?

Tape can only be cut at the marks indicated by the manufacturer, where the circuit is designed to be severed. Cutting elsewhere damages the line and compromises the seal. A strip light, however, cannot be cut: you choose the right length from the start. For models exposed to rain, see the models with a high protection rating.

Which IP rating should you choose for an outdoor LED strip light?

The IP rating has two digits: the first for dust, the second for water. The higher they are, the more the fixture withstands exposure. Under a sheltered canopy, moderate protection may be enough; facing rain or water jets, aim for a high rating. Always read the stated IP on the product sheet before confirming.

IP44, IP65: what each rating really protects against

IP44 protects against solid objects and water splashes, which suits a sheltered area. IP65 adds resistance to water jets and dust, useful on an exposed facade. The common mistake is to trust the word outdoor without reading the rating: it says nothing about the real protection. Find the waterproof outdoor LED strip lights.

Seaside, exposed facade, damp garage: what to check

By the sea, salty air attacks fixings and surface treatments. On an exposed facade, the orientation must let water run off instead of pooling on the seals. In a garage, a workshop or a damp cellar, the same rating protects the electronics and the diffuser, as with linear lighting for garages and workshops.

Warm white or neutral white: which colour temperature for outdoors?

Warm white creates a welcoming mood, suited to an entrance, a terrace or a relaxation corner. Neutral white lights passage, work and safety areas more directly. The choice follows the use, not the trend. A dimmable model or one fitted with a sensor can then be controlled through the evening.

Warm white, neutral white: which mood for which area?

Around 2700 to 3000 K, the light leans towards orange and warms a stone facade or a terrace wall. Around 4000 K, it becomes whiter and suits a garage or a passage where details need to be seen. Avoid mixing two whites on the same wall, the difference is immediately visible. Compare the moods in all Designix light fixtures.

Dimmable, motion sensor: how do you control outdoor lighting?

A dimmable model adjusts the intensity according to the hour, handy on a terrace used in the evening. A sensor switches on when someone passes and turns off on its own, which suits a path, a staircase or a rarely used access. In a living area, it quickly becomes annoying. The solutions for damp rooms rely on the same control principle.

How do you install and maintain an outdoor LED strip light?

Fix the fixture to a support suited to the material, concrete, wood or cladding, respecting the orientation intended for water drainage. Check that the seals and cable glands are tight when mounting. Then clean the diffuser with soapy water, without abrasive, to preserve the surface treatment.

Wall mounting, under a canopy or on the ceiling: which installation?

On the ceiling, the light goes downwards and illuminates a passage without glare. Mounted on a wall facing down, it highlights a wall and lights the ground below. On cladding, plan fixings that do not pierce the cover board. The LED strip lights for workshops detail ceiling installations above a worktop.

Seals, connections and cleaning: the care that extends service life

A poorly fitted seal lets water in and ages the electronics faster than the LED itself. Check the cable glands and connections once a year, tighten if needed. A soft cloth and soapy water are enough, as solvents dull the diffuser. The rest of the LED strip light collection follows the same rules.

LED strip light, LED wall light or ceiling light: which fixture for which area?

The strip light illuminates a long surface continuously, facade, canopy or garage. The LED wall light illuminates one precise point, an entrance or a gable. A waterproof ceiling light suits sheltered spaces such as a covered yard. The choice depends on the surface to be covered and the mounting height available on site.

Lighting a long facade or a large wall

On a facade, a continuous line gives an evenly lit wall and avoids the patchy effect. Two well-spread strip lights cover a very large wall better than a single one placed in the centre. The mounting height is set by the area to be lit, often around two to three metres for a passage. See choosing your fixture room by room.

Lighting an entrance point: LED wall light or waterproof ceiling light

Above a door, a wall light facing down illuminates the threshold without glare. Under a covered yard, a waterproof ceiling light remains the simplest solution to install. For a very wide entrance, the strip light regains the advantage through its continuity. The LED strip lights for bathrooms show waterproof models designed for damp conditions.

What sets a durable model apart from an entry-level strip light?

Longevity depends on the body material, the quality of the diffuser and the tightness of the seals, more than on appearance. Properly treated aluminium and a well-fitted seal age better outdoors. These criteria explain the budget gap between an affordable model and a more refined piece.

Body, diffuser and seals: where longevity is decided

Aluminium dissipates heat and withstands temperature swings better than a thin plastic body. A polycarbonate diffuser lets light through without yellowing too quickly. A supple sealing gasket and a well-tightened cable gland limit water ingress. These three elements can be checked on the product sheet and at installation. Find our entire lighting universe.

Budget: why two comparable strip lights do not cost the same

With a similar light output, a more refined model stands out through its material, its surface treatment, its seal and its control. A sensor or a dimmable function also add electronics. For daily use exposed to rain, that difference pays off over time. For a sheltered room, an affordable model is often enough.

How do you order your outdoor LED strip light with confidence?

To choose an outdoor strip light, check the product sheet for the mounting method, the stated IP protection rating and the colour temperature suited to the use. On unboxing, check the fixings and the condition of the product.

Secure payment, tracked delivery and returns

Payment is made over a secure connection. Delivery is tracked, so you know the date of receipt. Returns remain possible if the model does not match the intended area. Check the dimensions on the product sheet before ordering: simpler than a round trip. See the available outdoor models.

Designix customer service before and after purchase

A question about an IP rating, a length or an installation? Designix customer service answers before the order and stays reachable afterwards. To broaden your search, compare with the other lighting families. Choose the strip light that covers your facade or canopy, check the IP and the colour temperature, then confirm your basket.

Frequently asked questions about outdoor LED strip lights